DTS DUAL CONSOLE REMOTE CONTROL WITH CAN TRACKPAD
Page 8 / 17 90-889224 MAY 2006
11. Detent tension adjustment screw - This screw can be adjusted to increase or decrease
the effort to move control handle out of detent positions (cover must be removed).
Turning the screw clockwise will increase tension. Adjust to tension desired.
a
b
ob01170
+
-
a - Detent tension adjustment screw b - Control handle tension adjustment
screw
Synchronizing Engines
The auto synchronizing feature, when engaged, will automatically adjust all engine
speeds to match the speed of the starboard engine.
Press the "SYNC" button on the CAN trackpad to turn auto synchronization on or off.
When the sync LED is yellow, the "SYNC" button has been pressed, but the conditions
are not right for auto synchronization to engage. When the sync LED turns red, engine
synchronization has been engaged. The engines will remain synchronized as long as
engine speed is over 900 RPM for two seconds, remote control handles are positioned
within 10% of each other, and the engines are below 95% throttle opening.
To disengage the auto synchronization feature, press the "SYNC" button.
SYNC
1 LEVER
NEUTRAL
TROLL
THROTTLE
ONLY
DOCK
TRANSFER
+
-
22590
Helm Transfer
!
WARNING
Avoid serious injury or death from loss of boat control. The boat operator should never
leave the active station while engine is in gear. Helm transfer should only be attempted
while both stations are manned. One person helm transfer should only be performed
while engine is in neutral.
NOTE: Neutral position is preferred when doing a station transfer. If conditions do not
allow the remote control to be placed in the neutral position, a helm transfer can be done
while in gear.
The helm transfer function allows the boat operator to select which helm is in control of
engine operation. Pressing the "TRANSFER" button two times allows engine control to
be transferred to a new helm. When a helm transfer is initiated, the control will
automatically start adjusting engine RPM and gear position to match the control handle
setting at the new helm. Adjust the control handles to the desired throttle and gear
position.
To Next Page
Loading...