DTS DUAL CONSOLE REMOTE CONTROL WITH CAN TRACKPAD
90-889224 MAY 2006 Page 3 / 17
IMPORTANT: After cutting mounting area, make sure opening is free of sharp edges.
a
3508
a - Template
Installing the Dual Console Control with CAN Trackpad
1. Ensure the opening is free of sharp edges.
2. Route the wiring for the remote control into opening.
3606
3. Insert the bayonet ends of the two lever harnesses into bracket holes. This will prevent
connectors from pulling out.
4. Ensure the trackpad connector is sealed with a weather cap.
5. Connect the CAN trackpad connector to a junction box.
To Next Page
Loading...