Mercury 877775A Series - Handle Tension Adjustments; Control and Detent Tension

DTS DUAL CONSOLE REMOTE CONTROL WITH CAN TRACKPAD
90-889224 MAY 2006 Page 5 / 17
7. Fasten the remote control with four M6 x 40 screws.
a
b
c
22127
N
E
U
T
R
A
L
+
-
TROLL
TRANSFER
SYNC
THROTTLE
ONLY
DOCK
1 LEVER
a - Mounting Screw (4) M6 x 40
b - Washer
c - Nut - nylon insert
!
CAUTION
Do not turn control handle tension adjustment screw clockwise more than 11 turns from
the initial point of hex head contact with bracket. Damage to the module may occur.
!
CAUTION
Do not turn detent tension adjustment screw clockwise more than 11 turns from full out
position. Damage to the module may occur.
8. Control handle tension adjustment screw – This screw can be adjusted to increase
or decrease the overall effort to move the control handle. This will help prevent the
handle from unwanted motion in rough water. Turn screw towards "+" to increase
tension or towards "–" to decrease tension.
9. Detent tension adjustment screw – This screw can be adjusted to increase or
decrease the effort to move control handle into or out of detent position. Turn screw
towards "+" to increase tension or towards "–" to decrease tension.
5102
a
b
a - Detent tension adjustment b - Control handle tension adjustment