Section 2 - On the Water
Page 20 90-8M0099745 eng MAY 2015
• Press the turn button in the direction of the desired heading change. Each press of the button changes the desired heading
by 10°.
a - Port turn (course adjust) button
b - Starboard turn (course adjust) button
c - Auto heading button and light
d - Resume button and light
• Deflect and hold the joystick in the desired direction for one second to make small adjustments in the chosen heading.
Each recognized movement adjusts the chosen heading by 1°.
NOTE: The joystick must move 100% of its travel for the movement to be recognized as input. A beep will sound.
Adjusting heading to starboard
To Resume a Heading
The resume light is on if the previous course heading is available to resume.
IMPORTANT: The previous heading can only be resumed within four minutes of the auto heading being disengaged by turning
the wheel past the detent or if the vessel has been turned no more than 90°.
Press the resume button to resume the previous heading, if you turned the steering wheel and disengaged auto heading.
Disengaging Auto Heading
1. Disengage the auto heading mode with any of the following actions:
• Place the ERC handles for all engines in neutral. The auto heading light turns off and the standby light comes on.
• Turn the steering wheel beyond the electronic detent. The auto heading light turns off and the resume light comes on.
• Press the auto heading button on the autopilot trackpad. The auto heading light turns off and the standby light comes
on.
2. A single beep sounds and the VesselView display will turn gray, showing that the mode is in standby.
To Next Page
Loading...
Need help?
General
