Section 5 - Predelivery (PDI) and Customer Delivery (CDI) Checklists
90-8M0099745 eng MAY 2015 Page 41
Customer Delivery Inspection (CDI)
IMPORTANT: This inspection must take place in the presence of the customer.
This checklist is for packages equipped with Axius Joystick Piloting. Refer to the engine operation manual for the standard
MerCruiser CDI checklist. Perform these tasks after the Predelivery Inspection (PDI).
N/A Completed Item
Safety:
Enable Throttle Only and demonstrate its ability to disable shifting of the electronic remote control and
joystick while the engines are running.
Joystick:
Demonstrate that the joystick requires both engines to be running to operate.
Rotate the joystick to port and starboard to demonstrate pivot capabilities.
Place the joystick to port to move the boat laterally while demonstrating the ability to compensate for current
and wind by rotating the top of the joystick and inputting slight forward and reverse inputs. Repeat going
starboard.
Enable docking mode to demonstrate reduced throttle response for the joystick maneuvers.
Upgrades:
Demonstrate methods to enable and disable Auto Heading, if equipped.
Demonstrate methods to enable and disable Skyhook, if equipped.
Demonstrate methods to enable and disable Autopilot Waypoint Sequencing, if equipped.
(Upgrade features can be disabled by moving the steering wheel, the ERCs, or by pushing the AP trackpad
feature button again.)
Steering wheel:
Demonstrate that the starboard keyswitch must be on for the steering wheel to autocenter and force
feedback.
Show the location of the 20 A circuit breaker.
Demonstrate the steering wheel autocenter feature.
Maintenance:
Explain hydraulic power steering fluid checks, fluid required, and service intervals for power steering filter (if
equipped).
To Previous Page
Loading...
Need help?
General
