40
CB804
Single Engine Trim / Trailer
Single engine applications will have a button that can be pressed to trim the drive unit up or down.
To raise the drive unit for trailering, beaching, launching and low speed, (below 1200 rpm) shallow water
operation push the trim button to raise the drive unit to the full UP / OUT position.
Some controls also have a trailer button that trims the drive to a position suitable only for trailer purposes.
Dual Engine Trim / Trailer
CAUTION
When lowering or raising sterndrives equipped with a dual engine tie bar kit, the sterndrives must be
raised or lowered evenly to prevent the tie bar from becoming twisted. Failure to raise or lower stern-
drives evenly may result in tie bar or sterndrive damage.
Dual engine applications may have a single integral button to operate both drive units simultaneously or may
have separate buttons for each drive unit.
Some controls also have a trailer button that trims the drives to a position suitable for trailer purposes only.
To Next Page
Loading...
Need help?
General