EasyManuals Logo

Mercury D1.7L DTI Alpha User Manual

Mercury D1.7L DTI Alpha
109 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #99 background imageLoading...
Page #99 background image
99
CD821
Excessive Engine Temperature
Possible Cause Remedy
Seacock closed or partially closed, if equipped Fully open seacock.
Clogged or improperly installed seawater strainer Clean or correct installation of seawater strainer
Drive belt loose or in poor condition Replace and/or adjust belt.
Seawater pickups obstructed Remove obstruction.
Faulty thermostat Replace.
Coolant level low in closed cooling section Check for cause of low coolant level and repair. Fill
system with proper coolant solution.
Heat exchanger cores plugged with foreign material Clean seawater side of water/water heat exchanger,
and seawater strainer.
Loss of pressure in closed cooling section Check for leaks. Clean, inspect and test pressure
cap.
Closed cooling section dirty Clean and flush.
Faulty seawater pickup pump Repair.
Seawater discharge restricted or plugged Clean exhaust elbow.
Seawater inlet hose kinked (restricted) Position hose to prevent kinking (restriction).
CD822
Insufficient Engine Temperature
Possible Cause Remedy
Faulty thermostat Replace.
CD823
Turbocharger - Noisy Or Rough Operation
Possible Cause Remedy
Poor lubrication / low oil pressure at turbocharger
Entry of foreign materials from intake or exhaust
side
Have inspected by an Authorized Mercury
Rubbing of compressor or turbine impellers against
housing
Have inspected by an Authorized Mercury
MerCruiser Dealer.
Bearing failure

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury D1.7L DTI Alpha and is the answer not in the manual?

Mercury D1.7L DTI Alpha Specifications

General IconGeneral
BrandMercury
ModelD1.7L DTI Alpha
CategoryEngine
LanguageEnglish

Related product manuals