73
CD796
77312
77068
2
6
71346
71347
5
1
4
73346
77044
A
2
CA73
THROTTLE CABLE
1 Lubricate pivot points with SAE 30W motor oil.
CA938
DRIVE UNIT AND TRANSOM ASSEMBLY
2 Lubricate gimbal bearing by applying approximately 8-10 pumps of grease from a typical hand-operated
grease gun using Quicksilver U-Joint and Gimbal Bearing Grease.
A Alpha Models - Lubricate hinge pins by applying a couple of pumps of grease from a typical hand-operated
grease gun using Quicksilver 2-4-C Marine Lubricant with Teflon.
3 For propeller shaft lubrication, see PROPELLER.
CB776
ENGINE COUPLER
4 Lubricate engine coupler splines through grease fitting on coupler by applying approximately 8-10 pumps of
grease from a typical hand-operated grease gun using Quicksilver Engine Coupler Spline Grease. If boat is
operated at idle for prolonged periods of time, coupler should be lubricated every 50 hours.
CB777
DRIVE SHAFT EXTENSION MODELS
5 Lubricate drive shaft grease fittings, at transom end, by applying approximately 3 - 4 pumps of grease from
a typical hand-operated grease gun using Quicksilver U-joint and Gimbal Bearing Grease.
6 Lubricate drive shaft grease fittings, at engine end, by applying approximately 3 - 4 pumps of grease from
a typical hand-operated grease gun using Quicksilver U-joint and Gimbal Bearing Grease.
To Next Page
Loading...
Need help?
General