EasyManuals Logo

Mercury MerCruiser 8.2 Horizon ECT User Manual

Mercury MerCruiser 8.2 Horizon ECT
83 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
Section 5 - Storage
90-8M0113925 eng DECEMBER 2015 Page 57
Draining Water from the Cool Fuel Module
Mercury MerCruiser recommends draining the Gen 3 Cool Fuel Module if it is equipped with a drain plug.
1. Remove the drain plug from the Gen 3 Cool Fuel Module and allow the water to completely drain from the module.
2. Inspect the drain plug and the O‑ring for damage. Replace if needed.
3. Place the O‑ring on the drain plug and apply Perfect Seal to the threads. Install the drain plug in the module drain hole.
Tighten the drain plug to finger‑tight.
a - Gen 3 Cool Fuel Module
b - Drain plug
c - O‑ring
Tube Ref No. Description Where Used Part No.
19
Perfect Seal Drain plug threads 92-34227Q02
Battery Storage
Whenever the battery will be stored for an extended period of time, be sure the cells are full of water and the battery is fully
charged and in good operating condition. It should be clean and free of leaks. Follow the battery manufacturer's instructions for
storage.
Recommissioning the Power Package
1. Ensure that all cooling system hoses are connected properly and hose clamps are tight.
!
CAUTION
Disconnecting or connecting the battery cables in the incorrect order can cause injury from electrical shock or can damage
the electrical system. Always disconnect the negative (‑) battery cable first and connect it last.
2. Install a fully charged battery. Clean the battery cable clamps and terminals and reconnect the cables. Tighten each cable
clamp securely when connecting.
3. Coat the terminal connections with a battery terminal anticorrosion agent.
4.
Perform all the checks in the Operation Chart.
NOTICE
Without sufficient cooling water, the engine, the water pump, and other components will overheat and suffer damage. Provide
a sufficient supply of water to the water inlets during operation.
5. Start the engine and closely observe instrumentation to ensure that all systems are functioning correctly.
6. Carefully inspect the engine for fuel, oil, fluid, water, and exhaust leaks.
7. Inspect the steering system, shift and throttle control for proper operation.
c
a
b
50410

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury MerCruiser 8.2 Horizon ECT and is the answer not in the manual?

Mercury MerCruiser 8.2 Horizon ECT Specifications

General IconGeneral
BrandMercury
ModelMerCruiser 8.2 Horizon ECT
CategoryEngine
LanguageEnglish

Related product manuals