FUEL & OIL
24
NOTE: At the end of the break-in period, visually check to see if the oil level in the oil injection system has dropped.
Oil usage indicates the oil injection system is functioning correctly.
GASOLINE/OIL MIXING RATIO CHART
Gas/Oil Ratio 3.8 liters (1 gal.) gas 11.5 liters (3 gal.) gas 23 liters (6 gal.) gas
50:1 (2%) 89 ml (3 fl. oz.) oil 237 ml (8 fl. oz.) oil 473 ml (16 fl. oz.) oil
MODELS WITHOUT OIL INJECTION
Use a 25:1 (4%) gasoline/oil mixture in the first tank of fuel.
After the break-in fuel mixture is used up, use a 50:1 (2%) gasoline/oil mixture. Follow the table for mixing ratios.
GASOLINE/OIL MIXING RATIO CHART
Gas/Oil Ratio 3.8 liters (1 gal.) gas 11.5 liters (3 gal.) gas 23 liters (6 gal.) gas
25:1 (4%) 148 ml (5 fl. oz.) oil 473 ml (16 fl. oz.) oil 946 ml (32 fl. oz.) oil
50:1 (2%) 89 ml (3 fl. oz.) oil 237 ml (8 fl. oz.) oil 473 ml (16 fl. oz.) oil
Filling Oil Injection System
1. Check oil level using the sight gauge in front of the outboard.
2. Remove the fill cap and fill tank with oil.
Capacity Fluid Type
Oil tank 3.2 liters (96 fl. oz.) Mercury or Quicksilver Premium 2-cycle TC-W3 outboard oil
3. Reinstall fill cap and tighten securely.
Filling Remote Oil Tank (If Equipped)
1. Remove fill cap and fill with the specified oil.
Capacity Fluid Type
Oil tank 11.5 liters (3 gal.) Mercury or Quicksilver Premium 2-cycle TC-W3 outboard oil
2. Reinstall filler cap and tighten securely.
3. Check oil level in the engine oil injection tank. The oil level should be 1/2 full to completely full. Refill if
necessary.
To Next Page
Loading...
