2. Remove fill cap and check fluid level. The fluid level should be even with the bottom of the fill hole. Add
Quicksilver or Mercury Precision Lubricants Power Trim & Steering Fluid. If not available, use automotive
(ATF) automatic transmission fluid.
Gearcase Lubrication
When adding or changing gearcase lubricant, visually check for the presence of water in the lubricant. If water is
present, it may have settled to the bottom and will drain out prior to the lubricant, or it may be mixed with the
lubricant, giving it a milky colored appearance. If water is noticed, have the gearcase checked by your dealer.
Water in the lubricant may result in premature bearing failure or, in freezing temperatures, will turn to ice and
damage the gearcase.
Remove the fill/drain plug and examine the lubricant draining from the gearcase for metal particles. A small amount
of metal filings or fine metal particles indicates normal gear wear. An excessive amount of metal filings or larger
particles (chips) may indicate abnormal gear wear and should be checked by an authorized dealer.
DRAINING GEARCASE
1. Place outboard in a vertical operating position.
2. Place a drain pan below outboard.
3. Remove vent plugs and fill/drain plug and drain lubricant.
To Next Page
Loading...
