a - Nylon insert locknut (11-826709113)
b - Flat washers
c - Nylon insert locknut (11-826709113)
d - Special washer head bolt (10-856680)
e - Spacer
Description Nm lb. in. lb. ft.
Special washer head bolt 27 20
Nylon insert locknut "a" 27 20
Nylon insert locknut "c" Tighten until seats, then back off 1/4 turn
Assemble steering link rod to steering cable with two flat washers and nylon insert locknut. Tighten locknut until it
seats, then back nut off 1/4 turn.
Assemble steering link rod to engine with special washer head bolt, locknut and spacer. First torque special washer
head bolt, then torque locknut to specifications.
Fuse Replacement
IMPORTANT: Always carry spare SFE 20 AMP fuses.
The electric starting circuit is protected from overload by an SFE 20 AMP fuse. If the fuse is blown, the electric
starter motor will not operate. Try to locate and correct the cause of the overload. If the cause is not found, the
fuse may blow again. Replace fuse with a fuse of the same rating
1. Open the fuse holder and look at the silver colored band inside the fuse. If band is broken, replace the fuse
with a new fuse with the same rating.
To Next Page
Loading...
