Need help?Do you have a question about the Mercury SmartCraft Systems Monitor and is the answer not in the manual?
General| Display Type | LCD |
|---|---|
| Operating Voltage | 12V DC |
| Alarms | Audible and visual alarms |
| Water Resistance | Yes |
| Connectivity | SmartCraft digital network |
| Compatibility | SmartCraft compatible Mercury and MerCruiser engines |
Explains the initial power-up sequence and the auto-detection process for engine type.
Details common error messages during engine type auto-detection and their solutions.
Step-by-step guide to reset the gauge to factory default settings.
Covers startup, engine hours, fuel used, and fuel flow displays.
Details RPM, trim, temperature, pressure, voltage, and oil status displays.
Explains range, water depth, vessel speed, and seawater temperature displays.
Instructions on how to configure the alarm to trigger when water depth falls below a set level.
Describes warnings for engine overheat, low oil reserve, and low water pressure.
Details warnings for water in fuel, engine overspeed, general malfunction, and oil pump faults.
Lists available display calibrations including units, trim pop-up, and specific data pages.
Step-by-step process to calibrate the trim sensor at 0.0, 10.0, and 25.0 positions.
Instructions to select English/Metric units and range units for displays.
Instructions to enable or disable various specific data display screens.
Outlines available calibrations for speed sensors, pitot input, and fuel tank settings.
Guide to setting the pitot water pressure sensor input for speed measurement.
Details how to adjust the paddle wheel speed sensor frequency for accurate readings.
Allows adjustment of the speedometer value to match other speedometers.
Instructions for entering capacity for Tank 1 and Tank 2.
Step-by-step calibration process for Tank 1 fuel level monitoring (0% to Full).
Step-by-step calibration process for Tank 2 fuel level monitoring (0% to Full).
To Next Page
