Mercury VesselView 4 User Manual

Section 4 - Setup and Calibrations
Page 26 90-8M0074776 eng MAY 2013
SmartCraft
Depth Offset >
Calibration: offset,
zero, restore
— —
Sea Temperature >
Sea temperature
source >
None, PCM0,
PCM1, PCM2,
PCM3, AirMar0,
AirMar1, AirMar2,
AirMar3
—
Offset >
Calibration: offset,
zero, restore, save
—
Speed >
GPS source > CAN‑P or H —
Pitot speed source
>
None, PCM0,
PCM1, PCM2,
PCM3,
—
Pitot sensor type > 100 or 200 PSI —
Pitot multiplier >
Calibration:
multiplier and
restore, save
—
Paddle speed
source >
None, PCM0,
PCM1, PCM2,
PCM3
—
Paddle speed
sensor >
Legacy or Airmar —
Paddle frequency >
Calibration:
multiplier and
restore, save
—
Steering >
Steering angle
source >
None, PCM0,
PCM1, PCM2,
PCM3, TVM
—
Invert steering
Turn on (check
mark) to invert
steering, or off (no
checkmark), which
engine to show
steering
—
Offset >
Calibration: offset,
zero, restore, save
—
Tanks >
Location: port, port center,
starboard center, starboard >
Tank 1 or 2 > Calibration > Empty, 1/4, ½, 3/4, full
Tank usage >
None, fuel, oil,
water, waste
—
Capacity > 0 up to six digits —
Trim >
Location: port, port center,
starboard center, starboard >
Has trim
Turn on (check
mark) or off (no
checkmark)
—
Calibration >
Set trim in,
maximum trim
range, full trim out,
reset, restore, save
—
Tabs >
Tab source >
None, PCM0,
PCM1, PCM2,
PCM3, TVM
— —
Starboard and port calibration
Number of
calibration points (2
or 3),
Set tab down, mid,
up range, reset,
restore, save
—

Mercury VesselView 4 Specifications

General

Brand	Mercury
Model	VesselView 4
Category	Marine Equipment
Language	English