To Next Page

To Previous Page

Chapter 3 Customize Your Network

3.4 Specify DHCP Server Settings

By default, the DHCP (Dynamic Host Conguration Protocol) Server is auto and the

extender acts as a DHCP server and dynamically assigns TCP/IP parameters to

client

devices from the IP Address Pool when the router’s DHCP server is disabled. You

can change the settings of the DHCP Server if

necessary.

1. Visit http://mwlogin.net, and log in with the password you set for the extender.

2. Go to Settings > Network > DHCP Server.

1. Select On to enable the DHCP Server of the extender.

2. Enter the starting and ending IP addresses in the IP Address Pool.

3. Enter other parameters if the ISP offers. The Default Gateway is automatically

lled in and is the same as the LAN IP address of the router.

4. Click SAVE.

3.5 Set High Speed Mode

The High Speed feature switches o one of the wireless bands to leave one high-

performance, super-fast network, ideal for HD streaming and gaming applications.

If most of your devices are connected to one wireless band, this feature can

increase the overall performance of your wireless network.

Note:

Before enabling this feature, please go to Settings > Wireless > Extended Network and check that the 2.4GHz

and 5GHz bands are both enabled. Additionally, if you are going to disable the 2.4GHz network, it’s recommended

Mercusys ME50G User Manual

Questions and Answers: