Chapter 4 – Management
Here you can switch to another adapter installed in your computer. The adapters successfully
installed in your computer will be listed in the drop-down menu if the adapters are supported
by this utility.
3) To switch to SoftAP mode.
Once enabled, the adapter will be able to work as an AP.
4) To change the power save mode. The default option is OFF.
Figure 4-7
4.3 About
The About screen gives you information about the Driver and Utility versions of the adapter.
Right-click on the
icon in your system tray and select About from the list.
Figure 4-8
150Mbps Wireless N Nano USB Adapter 28
To Next Page
Loading...
