300Mbps Enhanced Wireless N Router User Guide
- 24 -
5.2.1 Host Network
Go to Wireless
Host Ne t wo r k, you can configure the settings for the wireless host network on
this page.
SSID (Wireless Network Name) - Enter a value of up to 32 characters. The default SSID is
MERCUSYS_XXXX (XXXX indicates the last unique four numbers of each router’s MAC
address). This field is case-sensitive.
Password - Enter 8-63 characters using a combination of numbers, letters and symbols. The
security version is WPA2-PSK/WPA-PSK, which supports AES encryption that provides a
good level of security. If you select No Security, the filed will be left blank.
Channel - This field determines which operating frequency will be used. The default channel
is set to Auto, so the router will choose the best channel automatically. It is not necessary to
change the wireless channel unless you notice interference problems with another nearby
access point.
Mode - Select the desired mode.
Select the desired wireless mode. It is strongly recommended to select 11bng mixed, and
all of 802.11b, 802.11g and 802.11n wireless stations can connect to the router.
11bgn mixed - Select if you are using a mix of 802.11b, 11g, and 11n wireless clients.
11n only - Select if you are using only 11n wireless clients.
If 11bg mixe d is selected in the Mode field, the Channel Width
selecting field will turn grey and
the value will become 20M, which is unable to be changed.
To Next Page
Loading...
