300Mbps Enhanced Wireless N Router User Guide
- 30 -
Targe t - Displays the target selected in the corresponding rule.
Schedule - Displays the schedule selected in the corresponding rule.
Edit - Here you can edit an existing rule.
Add - Click to add a new rule entry.
Delete All - Click to delete all the entries in the table.
Delete Selected - Click to delete selected entries in the table.
To add a new rule, follow the steps below.
1. Toggle on to enable Access Control.
2. Select Whitelist or Blacklist.
3. Click Add and enter a brief description for the rule.
4. Click Configure in the Hosts Under Control column to add a host, then click Apply.
Host Description - In this field, create a unique description for the host.
Mode - Here are two options, IP Address and M AC Add re ss. You can select either of
them from the drop-down list.
If the IP Address is selected, you can see the following item:
IP Address Range - Enter the IP address or address range of the host in dotted-decimal
format (e.g. 192.168.0.23).
To Next Page
Loading...
