28
Using the DSP
loudspeakers
Selecting a source
When not playing, the DSP loudspeakers should be
left in the standby state. This uses a negligible amount
of electricity, but ensures that the components of the
loudspeakers operate at maximum efficiency from the
moment you start.
If you are not going to use the DSP loudspeakers for
several days you should switch each unit completely off
at the back panel, and disconnect it from the AC power
supply.
To select a source
Press the appropriate source key on the remote; eg
Radio.
This will bring the DSP loudspeakers out of standby,
and the displays will show the currently selected source
and volume setting.
For example:
Radio65
Initially all the sources are set to use the RJ45 digital
input. To configure all sources to use the co-axial input,
configure the speaker as M.Coax or S.Coax; see
To choose master or slave and the primary connector
,
page 34. To configure an individual source to use a
different input see
To configure a source
, page 37.
To switch to standby
Press Off on the remote.
The displays will show:
.
•
•
To Next Page
Loading...
Need help?
General
