35
Configuring the DSP
loudspeakers
Initially all sources will be configured to use the primary
input you have specified, but you can configure
individual sources to use the other input; see
To
configure a source
, page 37.
For example, to define the left speaker as a slave using
the digital co-axial connectors:
The display shows:
L.S.Coax
When you have configured the loudspeaker:
Switch off the DSP loudspeaker, using the power
switch on the back, and then switch on again to
restore normal operation.
•
To Next Page
Loading...
Need help?
General
