Merivaara PRACTICO - 4.6.8 Leg Section Gas Spring; 4.7 Replacement of Castors; 4.7.1 Castor Adjustment

25
4.6.8 Replacement of leg section gas spring
Remove the leg section from the operating table and
turn upside down.
• Re move scre ws (1).
• Remove bushings (2).
• Tu rn the ac ces s ory rail (3) to th e si de .
• Remove locking rings (4)
• Remove pins (5).
• Remova l of gas spring from protective tubing
(see section 4.6.6 page 24)
4.7 Replacement of castors
• Raise the table base casing (see section
4.3.2 page 15)
• Put the brake pedal (1) into its free position.
• Loo sen screws (3).
• Loo sen screws (4).
• Move the brake bar to the side. (2).
• Remove the castor.
• Reinstall castor in reverse order. Ensure that the
brake pedal and cam positions are in alignment
and th at the ca stor is facing in the rig ht direction.
4.7.1 Castor adjustment
• Engage the brakes.
• Loo sen screws (3).
• Move the brake bar to the side (2).
• Braking power is increased by turning the castor axle
counter-clockwise one rotation at a time (as seen from
above). Use a large screwdriver or similar tool.
o
1
0
4
6
u
.
p
d
f
5
1
2
6
4
4
5
3
o
1
0
4
6
r
.
p
d
f
21 33 4
4
o
1
0
4
6
s
.
p
d
f
2