Operating condition requirements
• As with all electrical appliances, it is recommended to have the electrical
connections inspected at least once a year.
• This appliance must be grounded. Connect only to a properly grounded outlet.
See Operations and Installation Guide – Section 2B.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to avoid a
hazard.
• The appliance must be disconnected from its power supply during
maintenance and when replacing parts.
Unplug appliance such that from any access point the operator can check
the plug remains removed.
Use of disconnection with a locking system in the isolated position is
recommended in order to avoid a hazard.
• Never remove the external covers of the appliance.
• Never remove any fixed internal parts of the appliance.
• Never tamper with the control panel, door, seals, or any other part of the
appliance.
• Never hang dish towels or cloths on any part of the appliance.
• The appliance must not be operated without the air filter in place.
• If the door or door seals are damaged, the oven must not be operated
until it has been repaired by a competent person. See Section 1E. Requirements to
be met by operating personnel.
Operating environment requirements
• This appliance is not intended for mobile use, such as in marine or vehicle
applications.
• The appliance must not be installed or operated outdoors.
• Ensure dry floor. The floor adjacent to the appliance may be slippery. Clean up
spillages immediately.
To Next Page
Loading...
