Personal protective equipment requirement
When installing or moving the appliance, ensure the following personal protective equipment is used:
• Protective gloves
• Safety boots
• Hard hat (e.g. when heavy loads are being lifted and working overhead)
To ensure local and national standards and regulations relating to workplaces in catering kitchens and the installation
location are observed, only Service Technicians are permitted to set up the appliance.
Safety precautions relating to the installation location
To prevent hazards that arise from the installation site and environment of the appliances, the following rules must
be observed:
• The floor adjacent to the appliance may be slippery. Clean up spillages immediately.
• The location for installation must comply with operating conditions requirements:
The ambient temperature lies between +4°C /40°F and +35°C/95°F
Not a toxic or potentially explosive atmosphere
Dry kitchen floor to reduce the risk of accidents
• Minimum space requirement must be complied with:
The minimum height of free space necessary above the top surface of the appliance is 50mm (2”).
The minimum depth requirement is as follows:
▪ Width of appliance = 406.4mm (16”)
▪ Total depth with door open = 806.9mm (31.8”)
▪ Counter depth = 499.0mm (19.6”)
Safety clearance on left-/right-hand side / at rear: 0mm
• The appliance must not be installed directly under a fire alarm or sprinkler system. Fire alarm installations
and sprinkler systems must be set up to handle the level of steam and vapour expected to escape from the
appliance when the door is opened.
• There is a risk of fire from the heat emitted from hot surfaces. Therefore, flammable materials, gases or
liquids must not be located near, on or below the appliance.
• It must be possible to set up the microwave combination oven in the installation position so that it cannot tip
over or slide about. The supporting surface must comply with these requirements.
• Vibrations must generally be avoided when using wheeled oven stands or wheeled stacking kits.
• Heat sources in the vicinity must lie at a minimum distance of 500mm (20”).
To Next Page
Loading...
