• The appliance must be installed so that there is absolutely no possibility that liquid from the appliance or
liquid coming from cooking processes can reach deep-fat fryers or appliances that use hot, uncovered fat.
Deep-fat fryers or appliances that use hot, uncovered fat, and which are located in the vicinity must lie at a
minimum distance of 500mm / 20in.
• Requirements for supporting surface is met.
The supporting surface must be flat and level.
The supporting surface must have a non-slip surface.
The supporting surface must be able to bear the in-use weight of the appliance, plus the weight of
the structure supporting the appliance as follows: 50Hz = 46kg /101lbs and 60Hz = 45kg / 99lbs.
Potential risks during installation and setting up
Risk of injury from lifting heavy weights incorrectly
When lifting the appliance, the weight of the appliance may lead to injuries, especially in the torso are. To avoid this:
• Use a fork-lift truck/pallet truck to move the appliance.
• Use suitable lifting gear.
• When lifting the appliance, use enough people for the weight of the appliance (value depending on age and
gender). Observe the local occupational safety regulations for lifting and carrying.
Risk of body parts being crushed when moving and setting the appliance down
To avoid crushing body parts, ensure these instructions are followed:
• Use suitable handling gear
• Move the appliance slowly and carefully, and secure it against tipping over
• Make sure centre of gravity is balanced and avoid jolts
• Ensure the supporting surface meets the requirements specified above
Risk of cuts from sharp edges
To avoid cuts, ensure personal protective equipment is used and exercise caution when handling sheet-metal parts.
Risk of trapping fingers or body in mechanical parts of the appliance
To avoid this risk, when opening or closing the door, ensure that the handle is used and keep clear of the door hinges.
Risk of electric shock from live electrical parts
Live electrical parts are to be found under covers, under the operating panel, along the mains power lead and on
metal parts adjacent to the appliance. As such, work on the electrical system must only be performed by qualified
electricians (as per EN50110-1 in EU or equivalent) from an authorised service company. To avoid risk:
• The appliance must not be installed or operated outdoors.
• The electrical supply must be connected in accordance with applicable local and national regulations and
regulations of the professional associations and of the relevant power supply company.
To Next Page
Loading...
