O
F
F
ON
10
Use only foot controller provided with this machine.
(Type 4C-316B for U.S.A. & CANADA only)
5. PREPARATION PRIOR TO SEWING
* Connect the controller/electric plug to the machine
receptacle.
* Plug power line into electric outlet.
* Power Switch: Push " l " mark side to turn "ON”
Push "O" mark side to turn "OFF”
* To run the machine and control the speed, press
the controller.
* The harder you press, the faster the machine will
sew.
* To stop the machine from sewing, remove your
foot from the controller.
POLARIZED PLUG INFORMATION (FOR U.S.A. & CANADA ONLY)
This appliance has a polarized plug (one blade wider than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only way. If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit contact a qualified electrician to install the proper outlet. Do not modify the plug in any way.
* Be sure that the electrical voltage of the electric outlet (wall receptacle) is the same as the rated voltage of
the motor.
* Handle the foot controller with care and avoid dropping it on the floor. Be sure not to place anything on top
of it when not in use.
* Disconnect the power line plug from the electric outlet when changing needles, presser feet or when
leaving the machine unattended. This eliminates the possibility of starting the machine by accidentally
pressing the controller.
4. NEEDLE INFORMATION
This overlock uses a flat shank industrial needle
that eliminates the possibility of inserting the needle
backwards.
Do not attempt to use a standard household sewing
machine needle of any size or type in this overlock.
Needle ELx705 size 14/90 is finished with the
machine.
Only use Needle ELx705 size 14/90 and 12/80 as
supplied in the accessory case.
ELx705
Overlock needle
To Next Page
Loading...
Need help?
General
