5
8
2
3
1
4
5
6
7
4
5
6
8
7
10cm
(4")
7
8
18
(2) TO THREAD THREADLOWER LOOPER
(RED)
* Thread the thread guide A (2) by pulling the thread
towards the left until it slips under guide.
Then pull thread along the path as illustrated.
* Thread the looper area of the machine following
the green color coded thread guides (4)~(7).
* Thread the hole in the upper looper from front to
back (8).
Note : Make sure thread passes behind lower
looper.
Note : Use tweezers provided in the accessory case
to aid in threading the looper.
* Pull about 10cm (4 inches) of thread through the
looper and place to the back of the stitch plate.
1
* Pass thread from back to the front through the
thread guide (1).
Thread the lower looper as indicated (1)~(8).
* Raise Presser foot to release Tension discs.
2
2
To Next Page
Loading...
Need help?
General
