Mesa 7I90HD - Power Connector Pinout; Jtag Connector Pinout

7I90HD 8
CONNECTORS
POWER CONNECTOR PINOUT
P7 is the 7I90HDs power connector. P7 is a 3.5MM plug-in screw terminal block.
P7 pinout is as follows:
PIN FUNCTION
1 +5V TOP, SQUARE PAD
2 GND BOTTOM, ROUND PAD
JTAG CONNECTOR PINOUT
P6 is a JTAG programming connector. This is normally used only for debugging or
if both EEPROM configurations have been corrupted. In case of corrupted EEPROM
contents the EEPROM can be re-programmed using Xilinx’s Impact tool.
P6 JTAG CONNECTOR PINOUT
PIN FUNCTION
1 TMS
2 TDI
3 TDO
4 TCK
5 GND
6 +3.3V