7I90HD 36
REFERENCE INFORMATION
LBP16
MEMORY SPACE 6 LAYOUT:
ADDRESS DATA
0014 LEDMode If LSb is 0, LEDs are "owned" by HostMot2,
otherwise LEDs are local debug LEDs
0016 DebugLEDPtr What variable in space 6 local debug LEDs show
(default is RXPktCount).
0018 Scratch Can be used for sequence numbers
001A EEPROMWEna Must be set to 5A0N enable EEPROM or flash
writes or erases (N is memory space of EEPROM
or flash) Note that this is cleared at the end of
every packet.
001C LBPReset Setting this to a non-zero value with do a full
reset of the LBP16 firmware. The 7I90HD will be
unresponsive for as much as ½ a second after
this command.
ERROR REGISTER FORMAT
BIT ERROR
0 LBPParseError
1 LBPMemError
2 LBPWriteError
3 RXPacketError
4 TXPacketError
5 HM2TimeOutError
6..15 Reserved
To Next Page
Loading...
