4 Functionality Page 12 of 25
COM200 module - Product Manual 1.0 MetCom Solutions GmbH
4.3 Push Support
4.3.1 General
The pushing process is done by using three main groups of COSEM objects as follows:
• Triggering Objects
• Script Table
• Push Set-up
Below figure depict the COSEM objects are involved in Pushing process and their relationship:
Figure 4: Pushing Process
As shown in above figure, the meter can be woken up by a trigger (internally or externally) to
connect to network and exchange data with Central System. This is called Triggering Process. The
following COSEM objects are considered to provide triggering:
• Push action scheduler – Interval_1
• Push action scheduler – Interval_2
• Push action scheduler – Interval_3
• Alarm Monitor 1
• Alarm Monitor 2
• Auto Answer (SMS)
A trigger calls a script in Push Script Table (0-0:10.0.108.255) and the called script invokes the
"Push" method of relevant "Push Setup" objects. At the end, the "Push" method of "Push Setup"
object sends the specified message/data to the Central System.
Node sayaç Çözümleri Ltd. Şti.
Metering Solutions
To Next Page
Loading...
Need help?
General
