KIT COMPONENTS
ISO-DIN
Brackets
(4) 5mm
Flat-head
Screws
(2) #6 Self-
tapping Screws
Equalizer
Dummy Plate
Faceplate
(2) Keps Nuts
99-3044
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
CHEVROLET
Blazer 1995-97........................................................1-3
S-10 Pickup 1994-97................................................1-3
GMC
Jimmy 1995-97........................................................1-3
Sonoma 1994-97......................................................1-3
ISUZU
Hombre 1996-97......................................................1-3
OLDSMOBILE
Bravada 1995-97.....................................................1-3
TOOLS REQUIRED
Cutting tool
Socket wrench
Phillips screwdriver
KIT FEATURES
Factory pocket
provisions
Equalizer
provisions
7
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
6
IF AN EQUALIZER WILL BE INCLUDED: Slide the aftermarket equalizer into the back of the
Radio Housing. Using the hardware included with the equalizer, mount the unit to the kit.
(see Fig. A)
IF AN EQUALIZER WILL NOT BE INCLUDED: Snap the Equalizer Dummy Plate into the
Radio Housing. (see Fig. B)
8
Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with (4) screws
previously removed in step #1.
3
(2) Carriage Bolts
(2) Equalizer
Spacers
Radio Housing
Fig. A
Fig. B
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 271202
To Next Page
Need help?
General
