TOOLS REQUIRED
Cutting tool
86-5618 - Head unit
removal keys
Phillips screwdriver
KIT COMPONENTS
rev. 130103
Radio Housing #1
Radio Housing #2
Shaft
Supports
Faceplate
ISO-DIN
Brackets
Snap Spacers
(4) #8 x ¾" Phillips
Pan-head Screws
(2) #6 Self-tapping Screws
Bracket #2
(Escort/Lynx)
Spacer Set #1
Bracket Set #1
(Econoline)
22
APPLICATIONS
FORD/JEEP/LINCOLN/MAZDA/MERCURY 1975-00
(SEE INSIDE FOR SPECIFIC APPLICATIONS)
45
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with those screws
previously removed.
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
AEROSTAR 1992-97, BRONCO II 1989-90, EXPLORER 1991-94, RANGER 1989-94,
CROWN VICTORIA 1991-94, GRAND MARQUIS 1991-94, ECONOLINE 1992-96, ESCORT
1991-96, TRACER (sedan) 1991-96, F-SERIES PICKUP 1992-96, BRONCO 1992-96,
TAURUS 1990-95, SABLE 1990-95, TEMPO 1989-94, TOPAZ 1989-94, THUNDERBIRD
1989-97, COUGAR 1989-97, CONTINENTAL 1988-94, MARK VII 1990-92, TOWN CAR
1990-94, MARK VIII 1993-95, ASPIRE, B-SERIES PICKUP, CONTOUR, MYSTIQUE,
MUSTANG, PROBE, WINDSTAR, MPV, MX3, MX6, PROTEGE, 626, CAPRI XR2,
VILLAGER, QUEST: For DIN units, using the scored lines on the back of the Faceplate as a
guide, cut and remove the shaft supports and mounting clips. Slide the DIN cage into the dash
(through the Faceplate) and secure by bending the metal locking tabs down. Slide the
aftermarket head unit into the cage until secure. (see Fig. A). For 2-Shaft units, make wiring
connections and slide the aftermarket unit into the dash. Slide the Shaft Supports over the
radio shafts and position them along the inner lip of the radio opening. Place the aftermarket
faceplate against the outer lip of the radio opening and secure with shaft nuts. (see Fig. B)
Fig. A
(Taurus / Sable
application
shown)
INST 5700
99-5700
AT-509FD
AW-509FD
DW-5510
INSTALLATION
INSTRUCTIONS
Fig. B
3c
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
To Next Page
Need help?
General
