Metra Electronics 99-5700 - FORD Bronco II; Ranger 1985-88 Installation; LINCOLN Mark VIII 1993-95 Installation; FORD Contour 1995-00; MERCURY Mystique 1995-99 Installation; LINCOLN Town Car 1984-89 Installation

4
17
Disconnect the negative battery terminal to
prevent an accidental short circuit. Using
Metra's 86-5618, pull the factory head unit
from the dash and disconnect the wiring.
FORD Contour 1995-00 / MERCURY Mystique 1995-99
21
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(4) Phillips screws from the top edge of the
dash trim bezel. Remove the light switch
knob, cigarette lighter and ashtray. Unsnap
the molding located below the dash trim
bezel and remove (4) screws exposed.
Remove (4) screws securing the factory
head unit and disconnect the wiring.
1
FORD Bronco II / Ranger 1985-88
2
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(3) #8 Phillips screws from the bottom of the
radio trim bezel. Unsnap the plastic strip
located above the bezel and remove (3)
Phillips screws exposed. Gently pull the
instrument cluster trim bezel away from the
dash and remove the radio trim bezel.
Remove (3) hex-head screws securing the
factory head unit and disconnect the wiring.
1
LINCOLN Town Car 1984-89
2
Disconnect the negative battery terminal to
prevent an accidental short circuit. Using
Metra's 86-5618, pull the factory head unit
from the dash and disconnect the wiring.
1
LINCOLN Mark VIII 1993-95
2
Cut and remove the shaft supports from the
Faceplate. Skip to step #3c in the
Installation Instructions for ALL VEHICLES
on Page #22.
Cut and remove the shaft supports from the
Faceplate. Skip to step #3c in the
Installation Instructions for ALL VEHICLES
on Page #22.
Cut and remove all mounting tabs on Radio
Housing #2 EXCEPT tabs "D" and "F".
The mounting tabs can be identified by the
stamped letter on the back of each tab.
Locate Spacer Set #1. (The Spacers must
be placed behind the mounting tabs during
installation in step #5). Skip to the
Installation Instructions for ALL VEHICLES
on Page #21.
Cut and remove all mounting tabs on Radio
Housing #2 EXCEPT tabs "D" and "F".
The mounting tabs can be identified by the
stamped letter on the back of each tab.
Locate Spacer Set #1. (The Spacers must
be placed behind the mounting tabs during
installation in step #5). Skip to the
Installation Instructions for ALL VEHICLES
on Page #21.
"F"
"D"
"F"
"D"