Metra Electronics 99-5700 - LINCOLN Continental 1985-87 Installation; FORD Crown Victoria 1991-94; MERCURY Grand Marquis 1991-94 Installation; LINCOLN Mark VII 1984-89 Installation; FORD Crown Victoria; LTD 1979-90; MERCURY Grand Marquis; Marquis 1979-90 Installation

16
5
Disconnect the negative battery terminal to
prevent an accidental short circuit. Using
Metra's 86-5618, pull the factory head unit
from the dash and disconnect the wiring.
1
FORD Crown Victoria 1991-94
MERCURY Grand Marquis 1991-94
2
Disconnect the negative battery terminal to
prevent an accidental short circuit. Gently
pry out on the dash trim bezel and remove.
Remove (4) 5mm hex-head sheet metal
screws securing the factory head unit and
disconnect the wiring.
1
LINCOLN Mark VII 1984-89
2
Disconnect the negative battery terminal to
prevent an accidental short circuit. Open
the ashtray and remove (2) Phillips screws
securing the dash trim bezel. Remove (4)
screws securing the factory head unit and
disconnect the wiring.
1
FORD Crown Victoria / LTD 1979-90
MERCURY Grand Marquis / Marquis 1979-90
2
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) #8 Phillips screws below the radio
opening. Open the ashtray and remove (2)
#8 Phillips screws exposed (it is NOT
necessary to remove the center screw).
Unclip and remove the dash trim bezel.
Remove (4) hex-head screws securing the
factory head unit and disconnect the wiring.
1
LINCOLN Continental 1985-87
2
Cut and remove the shaft supports from the
Faceplate. Skip to step #3c in the
Installation Instructions for ALL VEHICLES
on Page #22.
Cut and remove all mounting tabs on Radio
Housing #2 EXCEPT tabs "D" and "F".
The mounting tabs can be identified by the
stamped letter on the back of each tab.
Locate Spacer Set #1. (The Spacers must
be placed behind the mounting tabs during
installation in step #5). Skip to the
Installation Instructions for ALL VEHICLES
on Page #21.
Cut and remove all mounting tabs on Radio
Housing #2 EXCEPT tabs "D" and "F".
The mounting tabs can be identified by the
stamped letter on the back of each tab.
Locate Spacer Set #1. (The Spacers must
be placed behind the mounting tabs during
installation in step #5). Skip to the
Installation Instructions for ALL VEHICLES
on Page #21.
Cut and remove all mounting tabs on Radio
Housing #2 EXCEPT tabs "D" and "F".
The mounting tabs can be identified by the
stamped letter on the back of each tab.
Locate Spacer Set #1. (The Spacers must
be placed behind the mounting tabs during
installation in step #5). Skip to the
Installation Instructions for ALL VEHICLES
on Page #21.
"F"
"D"
"F"
"D"
"F"
"D"