Metra Electronics 99-6527B - Ram Vehicle Dash Disassembly

99-6527B
2
Dash Disassembly
1. Remove the rubber tray liner inside
the tray at the top center of the
dash, and then remove the (2) Torx
T-20 screws exposed. (Figure A)
2. Remove the rubber tray liner from
inside the small pocket on the
passenger side of the center dash
panel, and then remove the (1) Torx
T-20 screw exposed. (Figure B)
(Figure C)
3. For models with a center console:
a. Remove the rubber liner from
the storage tray in front of
the center console, and then
remove the (2) Phillips screws
exposed. (Figure C)
b. Remove the rubber liner from
the middle of the center
console, and then remove the
(1) Phillips screw exposed.
(Figure C)
c. Remove the rubber liner from
the rear of the center console,
and then remove the (2) Phillips
screws exposed. (Figure C)
d. Unsnap and remove the top of
center console.
Continued on the next page
(Figure B)
(Figure A)