Metra Electronics 99-7581 - Kit Assembly; Double DIN Head Unit;Stacked ISO Mount Units Provisions

99-7581
5
KIT ASSEMBLY
Mount the factory brackets onto the
aftermarket radio or stacked ISO
units using the hardware supplied
with the new radio.
1
A
Remove the (2) T-20 Torx screws
from the factory a/c vents in the
factory radio trim panel that will
secure the DDIN trim plate.
(Figure A)
2
DOUBLE DIN HEAD UNIT/STACKED ISO
MOUNT UNITS PROVISIONS
Secure the DDIN trim plate to the
factory radio trim panel using the (2)
T20 Torx screws removed in step 2.
3