Metra Electronics 99-8713 - Double DIN Radio Provision

5
99-8713
KIT ASSEMBLY
2
A
Snap the Double DIN brackets to the
inside edge of the radio housing.
(
Figure B)
3
Slide the Double DIN radio into the
Double DIN bracket/radio housing
assembly and secure the radio to the
kit using the screws supplied with
the radio. (
Figure C)
Cut and remove the center bar from
the Radio Housing. (
Figure A)
1
Snap the Double DIN trim-plate over
the front of the housing/radio
assembly. (
Figure C)
4
B
C
DOUBLE DIN RADIO PROVISION
Note: Refer also to the instructions included with the aftermarket radio.
Continue to final assembly.