Metrohm PGSTAT302N User Manual

Insert new module for the Autolab 8-Series
1 | Page
INSERT NEW MODULE FOR THE
AUTOLAB 8-SERIES
Editorial
Metrohm Autolab B.V.
Kanaalweg 29 G, 3526 KM Utrecht
The Netherlands
Tel: +31 30 2893154
Fax: +31 30 2880715
E-mail:
autolab@metrohm-autolab.com
Website:
www.metrohm-autolab.com
© Copyright 2011 Metrohm Autolab

Metrohm PGSTAT302N Specifications

General

Brand	Metrohm
Model	PGSTAT302N
Category	Measuring Instruments
Language	English

Summary

Introduction to Autolab Instrument Casings

Overview of Loose Autolab Modules and Compatibility

Opening the Autolab Cabinet for Module Installation

Procedure for Inserting New Autolab Modules

Autolab Analog Bus Wiring Diagram

Analog Bus Adjustments for FRA2 and FRA32M Modules

FRA2 Module Connections to PGSTAT Analog Board

Details the SMB cable connections for the FRA2 module to the PGSTAT analog board.

FRA32M Module Connections to PGSTAT Analog Board

Details the SMB cable connections for the FRA32M module to the PGSTAT analog board.

Analog Bus Adjustments for the ECD Module

Analog Bus Adjustments for the ADC10M Module

Trigger Cable for SCAN250 and ADC10M Module Combination

Analog Bus Adjustments for the BA Module

BA Module Connections with FRA2 Module Present

Connects BA module to PGSTAT and FRA2 using SMB coaxial cables.

BA Module Connections with FRA32M Module Present

Connects BA module to PGSTAT and FRA32M using SMB coaxial cables.

BA Module Connections Without FRA2 or FRA32M Module

Connection steps for the BA module when FRA2 or FRA32M are absent.

Connecting the ECN Module to the ADC164 Module

Connecting the pX1000 Module to the ADC164 Module

Calibration of FRA32M and FRA2 Module with Nova

Determination of C1 Parameter

Steps to determine the C1 parameter using Nova software and the Autolab Dummy cell.

Determination of C2 Parameter

Steps to determine the C2 parameter using Nova software and the Autolab Dummy cell.

Troubleshooting: No Calibration Possible for FRA Modules

Verifying FRA Module Calibration with NOVA

Post-Installation Module Testing Procedure