To Next PageTo Next Page
Need help?Do you have a question about the Metrohm PGSTAT128N and is the answer not in the manual?
General| Type | Potentiostat/Galvanostat |
|---|---|
| Compliance Voltage | ±12 V |
| Maximum Current | ±1 A |
| Frequency Range | 10 µHz to 1 MHz |
| Communication Interface | USB, Ethernet |
| Software | NOVA |
| Channels | 1 |
| Sampling Rate | 100 kHz |
| Current Range | 1 nA to 1 A |
| Measurement Resolution | 16 bit |
Steps to detach the front panel for module installation or access to internal components.
Diagram illustrating the default analog bus wiring within the Autolab instrument.
Connecting the FRA2 module to the PGSTAT analog board using SMB cables.
Connecting the FRA32M module to the PGSTAT analog board using SMB cables.
Connecting the ECD module to the control amplifier using an SMB cable.
Installing a ferrite bead on the analog bus for the ADC10M module.
Installing a trigger cable when SCAN250 and ADC10M modules are used together.
Connecting the BA module to PGSTAT and optional FRA modules using SMB cables.
Connecting the ECN module to the ADC164 module using an analog bus connector.
Connecting the pX1000 module to the ADC164 module using an analog bus connector.
Procedure for measuring and setting C1 and C2 parameters for FRA modules in Nova.
Step-by-step guide to determine the C1 calibration parameter using the dummy cell.
Step-by-step guide to determine the C2 calibration parameter using open leads.
Using typical C1 and C2 values when calibration is not feasible.
Performing tests in NOVA to verify the successful calibration of FRA modules.
