Metrohm Autolab 8 Series - User Manual

Insert new module for the Autolab 8-Series
1 | Page
INSERT NEW MODULE FOR THE
AUTOLAB 8-SERIES
Editorial
Metrohm Autolab B.V.
Kanaalweg 29 G, 3526 KM Utrecht
The Netherlands
Tel: +31 30 2893154
Fax: +31 30 2880715
E-mail:
autolab@metrohm-autolab.com
Website:
www.metrohm-autolab.com
© Copyright 2011 Metrohm Autolab

Metrohm Autolab 8 Series Specifications

General

Model	Autolab 8 Series
Voltage Range	±10 V
EIS Frequency Range	10 μHz to 1 MHz
Bandwidth	1 MHz
Software	NOVA
Frequency Range	1 MHz
Communication Interface	Ethernet
Applications	Battery Research, Sensor Development

Summary

Autolab 8-Series Casing Identification

Loose Module Compatibility Overview

Opening the Autolab Instrument Cabinet

Safely Removing the Autolab Front Panel

Step-by-step guide to safely remove the front panel of the Autolab instrument for module installation.

Installing New Modules into the Autolab

Connecting Installed Modules to the Analog Bus

Details on connecting installed modules to the Autolab's analog bus, including specific requirements for various modules.

Autolab Analog Bus Wiring Overview

Analog Bus Adjustments for FRA2;FRA32 M Modules

FRA2 Module Analog Bus Connections

Instructions for connecting the FRA2 module to the PGSTAT analog board using SMB cables.

FRA32 M Module Analog Bus Connections

Instructions for connecting the FRA32M module to the PGSTAT analog board using SMB cables.

Analog Bus Adjustments for ECD Module

Analog Bus Adjustments for ADC10 M Module

Trigger Cable for SCAN250;ADC10 M Combination

Analog Bus Adjustments for BA Module

BA Module Connections when FRA2 is Present

Connecting the BA module via SMB cables when the FRA2 module is also present in the instrument.

BA Module Connections when FRA32 M is Present

Connecting the BA module via SMB cables when the FRA32M module is also present in the instrument.

BA Module Connections without FRA2 or FRA32 M

Instructions for connecting the BA module when FRA2 or FRA32M modules are not installed.

Connecting the ECN Module to ADC164

Connecting the pX1000 Module to ADC164

Calibrating FRA32 M and FRA2 Modules with Nova Software

Determining C1 and C2 Calibration Parameters in Nova

Steps to determine the C1 and C2 calibration parameters for FRA modules using the Nova software.

Procedure for Determining the C1 Parameter

Detailed procedure for measuring and setting the C1 parameter for FRA module calibration in Nova.

Procedure for Determining the C2 Parameter

Detailed procedure for measuring and setting the C2 parameter for FRA module calibration in Nova.

Using Typical Values When Calibration is Not Possible

Alternative procedure using typical C1/C2 values if calibration is not feasible, impacting measurement accuracy.

Verifying FRA Module Calibration in Nova

Performing a dedicated test in Nova to confirm the correct calibration of the FRA module.

Testing Installed Autolab Modules