Metrohm Autolab 8 Series - Default Chapter; Table of Contents

Insert new module for the Autolab 8-Series
2 | Page
Table of Contents
1 – Introduction ............................................................................................................ 3
2 – Overview table loose modules ................................................................................ 4
3 – Opening the Autolab cabinet .................................................................................. 5
4 – How to insert the new module(s) ............................................................................ 8
5 – Analog bus overview ............................................................................................ 10
6 – Analog bus adjustments for the FRA2 or FRA32M module .................................... 10
6.1 – Connections for the FRA2 module ................................................................ 10
6.2 – Connections for the FRA32M module ........................................................... 11
7 – Analog bus adjustments for the ECD module ........................................................ 12
8 – Analog bus adjustments for the ADC10M module ................................................ 13
9 – Trigger cable for SCAN250/ADC10M combination ................................................ 14
10 – Analog bus adjustments for the BA module ........................................................ 16
10.1 – If the FRA2 module is present ..................................................................... 16
10.2 – If the FRA32M module is present ................................................................ 17
10.3 – If the FRA2 or FRA32M module is not present ............................................ 18
11 – Connections to the ECN module ......................................................................... 18
12 – Connections to the pX1000 module ................................................................... 19
13 – Calibration of the FRA32M and FRA2 module with Nova .................................... 20
13.1 – Determination of the C1 and C2 parameter in Nova ................................... 22
13.1.1 – Determination of C1 ....................................................................... 22
13.1.2 – Determination of C2 ....................................................................... 26
13.2 – No calibration possible ................................................................................ 30
13.3 – Verification of the calibration of the FRA module ........................................ 31
14 – Module test ........................................................................................................ 31