B - Installation of a DiSEqC 1.0 switch
If you install 2 or more dishes, or 2 LNB on the same dish, you must connect all the LNB
to a switch, featured with one single output, allowing to run one cable between the dish
and the receiver. For the installation, align each dish / each LNB just as if it was alone,
connecting directly this LNB to the receiver with one cable, without any switch. Once all the
dishes are aligned, install the switch and alter the settings of the receiver to properly drive
the switch.
Example for 2 dishes on Astra and Hotbird, Astra beeing connected to the input 2 (or
B) of the switch, and Hotbird beeing connected to 1 (or A)
Settings
See programmings steps of § 3A page 11.
@ You can now watch all pre-programmed channels from Astra and Hotbird.
To Next Page
Loading...
