17 - Timer
The timer is a tool that allows the receiver to switch ON on a specific channel at a programmed
time, for scheduled recordings. Attention, the wake up of the digital satellite receiver doesn’t
launch the recording on the VCR. Don’t forget to program a timer on your VCR too !
Important notice : some TV set will wake up automatically when the satellite receiver will wake
up. In order to avoid this, simply switch off the TV with the manual switch generally located on
the front panel.
To create a wake up event :
• Go to MENU / Config / Timer Settings
• The lines marked OFF are empty “slots” where you can program an event (wake up, standby,...)
Choose with the 56arrows the first empty slot and press OK
• On the line Timer State, press 4 to select enable
• On the line Timer Cycle, select One Time for a single event, Every Day for a daily event or Every
Week for a weekly event.
• On the line Timer service, select Wake Up
• On the line Date, input the date of the event
• On the line Wake Up Time, input the start time of the event
• On the line Channel, press OK to display the channel list and select the channel.
• Once your settings are complete, press the black key to save and exit
To create a Standby event :
Use the same procedure as above, but replace Wake Up by Sleep
To delete an event :
• Go to MENU / Config / Timer Settings.
• Select with the 56 arrows the event you want to delete.
• On the line Timer State, press 4 to select Disable.
• Press on the black key to save and exit.
To Next Page
Loading...
