Connect the cables and the leads as indicated on the figure below (figure #5).
When 2 satellite receivers control the same motor, it is important that each one of
them give the same number to a given satellite. For an easier installation of your
new digital receiver, locate the classification of the satellites used by your previous
receiver.
7 -
Connection on a motorised DiSEqC 1.2 unit already aligned
figure 5
OR
For each satellite you want to receive in digital, it is necessary to proceed as follows:
Example on HotBird
• Go on the reference channel (see table #1 page 9) satellite by typing the channel number
then OK.
• Go to MENU / Installation / Antenna Setup
• On the DiSEqC Mode field, select DiSEqC 1.2 with 34 arrow keys
• Press the the red key to save.
• Press the green key to access the Motor Setup menu
(in the future, you won’t need to do these first 4 steps, simply press the black key for direct
To Next Page
Loading...
