Metronic TouchBOX 3 - Connection on an Already Installed Dish

23
N - Adjustment of the electronic limits
Adjustment of the East limit
Adjustment of the East limit
• Press the black key to access the Motor Setup menu
• Go to the line Move, press and hold the 3 arrow key to drive the motor East and get ready
to press the key OK when the border of the dish reaches the obstacle.
• Go to the line Set Limit, and select East Limit with 3 arrow key
• Press OK to set the East limit and confirm with OK.
Adjustment of the West limit
Adjustment of the West limit
• Press the black key to access the Motor Setup menu
• Go to the line Move, press and hold the 4 arrow key to drive the motor West and get ready
to press the key OK when the border of the dish reaches the obstacle.
• Go to the line Set Limit, and select West Limit with3 arrow key
• Press OK to set the East limit and confirm with OK.
The receiver being disconnected from the mains, connect directly the LNB to the LNB receiver
input. Connect a scart lead from the television to the receiver TV output scart socket. Switch on
the television, connect the receiver on the power supply, the red LED is ON. Press the power
key
( )
of the remote control, the green LED lights on. Check in the list of the pre programmed
channels at the end of the user manual. You can select and watch the channel of this satellite.
5 - Connection to an already installed dish