Infrared receiver (detects the remote control infrared signal).
Signal indicator. Switch on if the receiver is good.
ON LED. Green when the unit is operating.
Standby LED. Red when the unit is in standby.
LNB entry to connect the input lead of the satellite.
LNB output to connect another satellite receiver if necessary.
Input / Output VCR scart. When you play a cassette, the VCR takes over automatically
on the receiver.
TV scart socket. To connect the receiver to the television.
RS232 connector for service only.
Mains lead.
Left and right audio outlets to enjoy digital sound with your your Hi-Fi gear.
Video output. Enable if the TV settings are set to CVBS in the MENU / Config / Video
Output / TV Mode.
Same as key 6 of the remote controler (OK).
Same as key 5 of the remote controler (CH
6 et CH5).
Same as key 4 of the remote controler (VOL
3 et VOL4).
Same as key 3 of the remote controler (MENU).
A
B
C
D
E
F
J
G
H
I
9 -
Description of front and rear panel
10 -
Day to day operation
K
L
E F
J
G H
I
KL
NM O P
M
N
O
P
B
A
D
C
Unless you want to alter the settings, you will use only the following keys whose function is
described in the preceding paragraph:
• Keys
34to adjust the sound volume.
• Keys 56 to change channels
• Key to switch off and switch on the sound.
• Digital Keys to go directly to a channel
• EPG Key to display current and following programme information.
• INFO Key to show programme information in another appearance.
• OK to display the channel list.
To Next Page
Loading...
