A - Installation of a bi-head satellite dish
If the receiver has factory settings (brand new or after reset of the
unit), you don’t have to modify the settings to drive a monobloc
(dual-head) LNB dish aimed at Astra (19°) and HotBird. In that
case, install the monobloc as depicted below and align the dish
on HotBird as explained in the previous paragraph. In the general
case, the following text explain how to alter the settings to declare
a DiSEqC 1.0 switch.
• Go on a channel from HotBird (eg 111:ZDF)
• Go to MENU / Installation / Antenna Setup
• On the line DiSEqC mode, select DiSEqC 1.0 with
the key 4
• On the line DiSEqC Port, select 1 with the key4
• Press on the red key (back arrow) to save.
• On the line Satellite, select Astra 19.
• On the line DiSEqC Port, select 2.
• Press on the black key to save and exit.
Alignment of the dish
• Install the monobloc on the dish arm as depicted
on the figure
• Align the dish on HotBird as explained in the previous paragraph
• Check that you receive channels from both Astra and HotBird
• If not, adjust the alignment to receive perfectly both satellites.
Attention, some models of monobloc may have a reverse setting. In that case, you must
change the programming of the receiver (Astra on input port 1 and HotBird on
input port 2).
3 - Installation on several satellites
To Next Page
Loading...
