C - Prepare the motor (see diagram 2)
Assembling
• Make sure the fixing (tube or stand off arm) is stable and strictly vertical. An error bigger
than 1 degree (2 cm, or 3/4 inch per meter) from the vertical will preclude the motor for
working properly. If necessary, add some block between the wall and the fixing. Check
the verticality with a spirit level or a plumb line.
• Make sure the fixing (tube or stand off arm) is stable and strictly vertical. An error bigger
than 1 degree (2 cm, or 3/4 inch per meter) from the vertical will preclude the motor for
working properly. If necessary, add some block between the wall and the fixing. Check the
verticality with a spirit level or a plumb line.
• Assemble together the parts of the motor (diagram 2). Put first the U-screws (1) through
the part (2). While assembling the part (2) with the body, pay attention to the washer (3) :
the part labelled «down» must be placed on the bottom, as shown on the picture.
• Once the motor is assembled, do not fix it straight away on the mast or the stand off arm,
some operations needs to be done near the receiver first.
To Next Page
Loading...
