Mettler Toledo IND360 - Steps to Add New Ind360 S

| 00 | 04/20212
METTLER TOLEDO IND360fill/dose Application EtherNet/IP Engineering
Notes
Parameters
Data
Type
Description
Param_Invalid
BOOL
ON if any of the parameters for the application
are invalid.
Param_Logic_Error
BOOL
ON if any of the parameters for the application
cause a logic error.
MB_Comm_Val
REAL
This should always be set to
MB1_Command_Value tag of the IND360.
Parameter sent along with the cyclic command
to the IND360.
MB_Command
REAL
This should always be set to MB1_Command
tag of the IND360. Value of the last cyclic
command sent to the IND360. Once
successfully executed, MB_Response =
MB_Command.
SB_Command
DINT
This should always be set to SB1_Command
tag of the IND360. Value of the last status
command sent to the IND360. Once
successfully executed, SB_Response =
SB_Command.
3 Steps to Add New
IND360s
Because EtherNet/IP uses IP addresses to distinguish between devices, when
multiple IND360s are networked the default IP address of each terminal must
first be modified.
Each IND360 must have a different IP address.
1. Click Communication-> Industrial Ethernet -> IP Address in the IND360
Advanced Service Mode in order to modify the IP address.