Mettler Toledo IND360 - Setup of Project Development Environment; Confirm EDS Installation

This Engineering Note demonstrates the integration of the METTLER TOLEDO
IND360's Fill/Dose Application with an EtherNet/IP PLC. Go to
www.mt.com/ind-ind360-downloads to download all the necessary files and
documents.
NOTICE
NOTE: THE CONFIGURATION USED IN THIS SAMPLE CODE IS BASED ON THE DEFAULT SETTINGS：
Rockwell Studio5000: Version 24
PLC: 1769-L30ER
SAI DATA FORMAT: 2-BLOCK FORMAT (DEFAULT), 8-BLOCK FORMAT
IND360 IP ADDRESS: 192.168.0.2
EDS FILE: MT_IND360_EIP_V1.1_20200728
IND360 DEVICE FIRMWARE VERSION: V1.00.0015
It is recommended to integrate one IND360 into the PLC EtherNet/IP network
and go through the sample code to understand the functionality of each Add-
On Instruction (AOI).
1 Setup of Project
Development
Environment
1.1. Confirm EDS Installation
This sample code project utilizes an EDS file for the IND360. These files can be
found on www.mt.com/ind-ind360-downloads.
To confirm installation of IND360 AOP file:
1. In any Studio 5000 project, right click on Ethernet within the I/O
Configuration folder in the controller organizer.
2. Select New Module….