Need help?Do you have a question about the Mettler Toledo Seven2Go pro and is the answer not in the manual?
General| Interface | USB |
|---|---|
| mV Range | -2000 to 2000 mV |
| Temperature Range | -5.0 ... 105.0 °C |
| Temperature Resolution | 0.1 °C |
| Temperature Relative Accuracy | ±0.1 °C |
| Display | LCD |
| Power | 4 x AA batteries |
| Power Supply | Batteries |
Defines signal words (WARNING, CAUTION, Attention, Note) and warning symbols used in the manual.
Covers intended use, location hazards, and general safety precautions for the instrument.
Provides a labeled diagram of the instrument's main components and features.
Describes the LTW socket for conductivity and temperature signal input.
Details the function and layout of the T-Pad and hard keys for navigation.
Lists and describes various icons displayed on the instrument screen.
Explains how to enable/disable acoustic signals for keypresses, alarms, and measurement endpoints.
Lists the standard equipment included with the new instrument.
Provides step-by-step instructions for installing batteries into the instrument.
Explains how to connect an external power supply via the Micro-USB socket.
Details the procedure for connecting an ISM® sensor and data transfer.
Details storage modes (automatic/manual) and destinations (memory, LabX Direct).
Covers system settings like language, time, date, access control, and user modes.
Explains the factory reset procedure and warns about data loss.
Details how to perform an instrument self-test to check components.
Covers standard selection, cell constant entry, and calibration reminders.
Settings for reference temperature, temperature correction, TDS factor, and units.
Describes endpoint types: Auto, Manual, and Timed.
How to enter, select, or auto-increment sample IDs.
How to enter, select, or delete user IDs.
How to enter, select, or delete sensor IDs and serial numbers.
Lists measurable parameters (Conductivity, TDS, Salinity, etc.) and units.
Step-by-step guide for performing conductivity measurements.
Step-by-step guide for performing TDS measurements.
Step-by-step guide for performing salinity measurements.
Step-by-step guide for performing resistivity measurements.
Outlines the structure of the data management menu.
Options for reviewing, transferring, and deleting measurement data.
Options for reviewing, transferring, and deleting calibration data.
Instructions for transferring data from the meter to a PC using LabX®direct.
Notes that software updates must be done by an authorized service agent.
Information on instrument repair services.
Guidelines for proper disposal of the instrument according to WEEE directive.
Lists different meter and kit versions with their order numbers.
Lists available accessories, solutions, and software with order numbers.
Table of conductivity standards at different temperatures.
Table of temperature correction factors for non-linear conductivity correction.
Table of temperature coefficients (alpha-values) for various substances.
Table of conductivity to TDS conversion factors for KCl and NaCl.
To Next Page